techFX mini tools has been released!

techFX tools is now shipping with all controller boards free! The software containsa board and sequence editor and programmer along with a USB bootloader to program new firmware into the techFX.

Features

With techFX tools, you can create a board configuration and control sequence in minutes and apply the controller to different projects fast and easily without writing any code!!

• Integrated USB bootloader for programming firmware
• Create,print,save,load controller configurations easily
• switch pins between input,output,PWM,A2D in seconds and program the configuration with a click of a button
• change # of A2D,PWM lines in seconds
• change the I2C bus speed for really long cable runs (100Khz,400Khz, or 1Mhz)
• Use the IOtester screen to test your pin configuration with your application device connected (ie: motor or sensor) and read values and execute functions before putting your application together
• Create,print,save,load control sequences with upto 255 commands and upto 60 minutes in length with a time resolution of a tenth of a second

Bootloader for programming firmware to the controller

IOtester screen for setting up your sensors and devices and testing the pin functions on them

Board configuration editor and programmer for quickly changing the board configuration to meet your application

Sequence editor and programmer for quickly creating control sequences based upon your programmed configuration

copyright 2006-2008 by Walter Dreksler